Racine County, Wisconsin
Village of Yorkville is a village in Racine County, Wisconsin. Village of Yorkville adopts its own zoning, so inside its limits Village of Yorkville’s rules apply, not the county’s. 10 rules below are quoted from official sources and independently re-checked, most recently on November 12, 2026. Rules for unincorporated land are on the Racine County page.
One- and two-family dwellings built, enlarged, altered or repaired inside the Village of Yorkville
“no one-family or two-family dwelling of which initial construction shall be commenced after june 1, 1980, shall be built, enlarged, altered or repaired unless a building permit for that work shall first be obtained by the owner, or his agent, from the building inspector.”
One- and two-family dwellings inside the Village of Yorkville
“the wisconsin administrative code provisions describing and defining regulations with respect to one-family and two-family dwellings in wis. admin. code chs. sps 320-325 are hereby adopted”
Land inside the Village of Yorkville (Racine County)
“attached at this end of the chapter as exhibit a, and incorporated herein by reference, is a copy of the current racine county zoning code which the village board hereby adopts as the zoning code for the village of yorkville.”
Zoning districts of the Racine County code adopted by Yorkville village
“r-1 country estate district r-2 suburban residential district (unsewered) r-2s suburban residential district (sewered-large lots) r-3 suburban residential district (sewered)”
R-2 Suburban Residential District (unsewered), Yorkville village
lot area minimum: >= 40000 sq ft · lot width minimum: >= 150 ft
“width minimum 150 feet area minimum 40,000 sq. feet height maximum 35 feet”
“width minimum 100 feet area minimum 20,000 sq. feet height maximum 35 feet”
R-2 Suburban Residential District (unsewered), Yorkville village
shore: >= 75 ft · street: >= 50 ft · rear: >= 50 ft · side: >= 15 ft
“(1) shore 75 feet (2) street 50 feet (3) rear 50 feet (4) side 15 feet”
“(1) shore 75 feet (2) street 35 feet (3) rear 50 feet (4) side (code 1975, § 7.033; ord. no. 97-203, 1-13-98) 10 feet”
R-2 Suburban Residential District (unsewered), Yorkville village
building height maximum: <= 35 ft
“width minimum 150 feet area minimum 40,000 sq. feet height maximum 35 feet”
“width minimum 100 feet area minimum 20,000 sq. feet height maximum 35 feet”
We looked and could not find an official answer yet. Silence is not permission; ask Village of Yorkville or Racine County directly.
Each answer was extracted from an official source and independently re-checked against that source by a second reviewer. That is an evidence check, not legal advice. Rules change; confirm with the authority before you buy or build.
Unanswered questions are usually a sign that Village of Yorkville publishes no rule on the point, not that none exists. Racine County’s page lists the county offices to call.
Off-grid gear
Going off-grid in Village of Yorkville means bringing your own water and power. The kit we’d start with:
These are affiliate links — we may earn a commission, at no cost to you. As an Amazon Associate, Bolthole Index earns from qualifying purchases.