Bolthole Index

Accomack County, Virginia

Zoning, building permits and septic rules in Town of Parksley, Virginia

Town of Parksley is a town in Accomack County, Virginia. Town of Parksley adopts its own zoning, so inside its limits Town of Parksley’s rules apply, not the county’s. 4 rules below are quoted from official sources and independently re-checked, most recently on November 12, 2026. Rules for unincorporated land are on the Accomack County page.

Answers from the rulebook for Town of Parksley

Town of Parksley’s own rules

  • Local zoningPresent

    Land inside Parksley town limits

    • Source is the 1995 ordinance as hosted by the U.S. Government Printing Office; whether it has since been amended or replaced was not verified because the town's own site/code host could not be found.
    “that the following be adopted as the zoning ordinance of the town of parksley, virginia, together with the accompanying map.”
  • Zoning districtsPublished

    Zoning districts inside Parksley town

    • Per the 1995 ordinance copy; current amendments unverified.

    districts: R-15, R-M, C-G, CBPA overlay

    “districts 16 residential, single-family (r-15) 20 residential, mixed (r-m) 23 commercial, general (c-g) 26 chesapeake bay preservation area overlay district (cbpa) 29”
  • Minimum lot sizeSpecified

    Residential, Single-Family (R-15) district inside Parksley town

    • Per the 1995 ordinance copy; current amendments unverified.
    • R-M district allows 15,000 sq ft for a single-family dwelling not served by public water and sewerage, plus 1,000 sq ft per additional unit for multi-family; the administrator may require more if the health official considers it necessary.

    minimum lot area: >= 15000 square feet

    “the minimum lot area required for a permitted use in the 11r-1511 district is 15,000 square feet.”
  • SetbacksSpecified

    Residential, Single-Family (R-15) district inside Parksley town, front setback from street right-of-way

    • Per the 1995 ordinance copy; current amendments unverified.
    • 60 feet from street centerline where right-of-way is under 50 feet wide.
    • No building need be set back more than the average of the setbacks of the two adjacent structures on either side.
    • Side and rear yard requirements not captured.

    front setback from street right-of-way 50 ft or wider: >= 35 feet (average of adjacent structures' setbacks may apply)

    “structures shall be located thirty- five (35) feet or more from any street right-of-way which is fifty (50) feet or greater in width”

Still unanswered

We looked and could not find an official answer yet. Silence is not permission; ask Town of Parksley or Accomack County directly.

  • Building permit — Building permits inside Parksley town
  • Owner-builder exemption — Owner-builder exemption inside Parksley town
  • Building code adopted — Building code inside Parksley town
  • Inspections — Building inspections inside Parksley town
  • Certificate of occupancy — Certificates of occupancy inside Parksley town
21 more unanswered
  • Minimum dwelling size
  • Lot coverage
  • Building height
  • Living in an RV
  • Camping on your land
  • Tiny homes
  • Manufactured homes
  • Accessory dwellings
  • Who permits septic
  • Septic permit
  • Septic inspection
  • Off-grid sanitation
  • Well permit
  • Mandatory utility hookup
  • Agricultural exemption
  • Subdividing land
  • Driveway access
  • Building in a floodplain
  • Short-term rentals
  • Permit fees
  • Permit process

Each answer was extracted from an official source and independently re-checked against that source by a second reviewer. That is an evidence check, not legal advice. Rules change; confirm with the authority before you buy or build.

Unanswered questions are usually a sign that Town of Parksley publishes no rule on the point, not that none exists. Accomack County’s page lists the county offices to call.

← All of Accomack County: county rules, score and offices