Galveston County, Texas
Santa Fe is a city in Galveston County, Texas. Santa Fe adopts its own zoning, so inside its limits Santa Fe’s rules apply, not the county’s. 6 rules below are quoted from official sources and independently re-checked, most recently on October 18, 2026. Rules for unincorporated land are on the Galveston County page.
Design, construction, and maintenance of structures and properties within Santa Fe's jurisdiction.
adopted code editions: 2018 International Building Code; 2018 International Residential Code; 2018 International Fuel Gas Code; 2018 International Mechanical Code; 2018 International Plumbing Code; 2018 International Energy Code; 2018 International Property Maintenance Code; 2018 International Swimming Pool and Spa Code; 2020 National Electrical Code (The City also lists 2018 Texas State Board of Plumbing Examiners Law/Rules.)
“In order to protect the general health, safety and welfare of the public, the City of Santa Fe has adopted the following Codes that will govern the design, construction and maintenance of structures and properties within our jurisdiction:”
Land and development within Santa Fe city limits.
“The City of Santa Fe has developed a Code of Ordinances and a Zoning Code to ensure that development and construction occurs in a responsible and safe manner. These codes have been adopted our City Council and are required to be followed.”
Zoning districts and development controls within Santa Fe city limits.
“The City of Santa Fe has developed a Code of Ordinances and a Zoning Code to ensure that development and construction occurs in a responsible and safe manner. These codes have been adopted our City Council and are required to be followed.”
Culvert driveway entrances connecting to City streets inside Santa Fe city limits.
minimum entrance width: >= 20 ft (Form states a maximum of 60 ft.) · maximum ditch closure: 40% of lot or tract frontage or 60 ft, whichever is less (Applies to open bar ditches of City streets.)
“Entrances shall have a minimum width of 20ft. Open bar ditches of City streets shall not be closed in an amount greater than 40% of the lot or tract frontage with along any given street or 60 ft, whichever is less, to preserve existing storm water detention capacity throughout the community. Culvert sizes and configurations shall be approved by the City of Santa Fe Streets Superintendent.”
City permit applications for land and construction inside Santa Fe city limits.
“All permit fees are due before permit issuance”
Residential and commercial permit applications inside Santa Fe city limits.
“The Building Official will review your permit package”
We looked and could not find an official answer yet. Silence is not permission; ask Santa Fe or Galveston County directly.
Each answer was extracted from an official source and independently re-checked against that source by a second reviewer. That is an evidence check, not legal advice. Rules change; confirm with the authority before you buy or build.
Unanswered questions are usually a sign that Santa Fe publishes no rule on the point, not that none exists. Galveston County’s page lists the county offices to call.
Off-grid gear
Going off-grid in Santa Fe means bringing your own water and power. The kit we’d start with:
These are affiliate links — we may earn a commission, at no cost to you. As an Amazon Associate, Bolthole Index earns from qualifying purchases.