Putnam County, New York
Town of Philipstown is a town in Putnam County, New York. 8 rules below are quoted from official sources and independently re-checked, most recently on October 23, 2026. Rules for unincorporated land are on the Putnam County page.
Work in Philipstown that must conform to the Uniform Code, Energy Code, or Town Code, including construction, enlargement, alteration, improvement, removal, relocation, demolition, and specified solid-fuel equipment work.
“Except as otherwise provided in Subsection B of this section, a building permit shall be required for any work which must conform to the Uniform Code and/or the Energy Code and/or the Town Code, including, but not limited to, the construction, enlargement, alteration, improvement, removal, relocation or demolition of any building or structure or any portion thereof, and the installation of a solid-fuel-burning heating appliance, chimney or flue in any dwelling unit.”
Permitted construction work in Philipstown where the listed inspection elements are applicable.
“Work shall remain accessible and exposed until inspected and accepted by the Code Enforcement Official or by an inspector authorized by the Code Enforcement Official.”
Dwelling units inside Philipstown.
minimum dwelling-unit floor area: >= 720 square feet (Accessory apartment minimum is 500 square feet.)
“Minimum floor area. The minimum floor area of a dwelling unit shall be 720 square feet and the minimum for an accessory apartment shall be 500 square feet.”
HM and HR Districts and conservation subdivisions inside Philipstown.
minimum lot size with common or municipal water but no common or municipal sewer: >= 40000 square feet · minimum lot size with common or municipal sewer only: >= 20000 square feet · minimum lot size with common or municipal water and sewer: >= 4000 square feet · minimum lot size without common or municipal water or sewer: >= 40000 square feet
“With common or municipal water supply but no common or municipal sewage disposal services: 40,000 square feet.”
Conventional and conservation subdivisions inside Philipstown.
“The number of units in a conventional subdivision is regulated by minimum lot size, while in conservation subdivisions it is regulated by a maximum density, as further described in Article V.”
Zoning, subdivision, and building applications inside Philipstown.
“Article III Zoning and Subdivision Fees § 71-7 Fee schedule. Article IV Building Fees § 71-8 Fee schedule.”
Building-permit applications inside Philipstown.
“Applications for a building permit shall be made, in writing, on a form provided by or otherwise adopted, replaced or changed by the Town Board.”
Town of Philipstown does not set these itself; the county, a health district or the state does, and they apply to every address inside its limits.
Buildings, structures, and premises in the Town of Philipstown.
“This chapter provides for the administration and enforcement of the New York State Uniform Fire Prevention and Building Code (the Uniform Code) and the State Energy Conservation Construction Code (the Energy Code) in the Town of Philipstown.”
We looked and could not find an official answer yet. Silence is not permission; ask Town of Philipstown or Putnam County directly.
Each answer was extracted from an official source and independently re-checked against that source by a second reviewer. That is an evidence check, not legal advice. Rules change; confirm with the authority before you buy or build.
Unanswered questions are usually a sign that Town of Philipstown publishes no rule on the point, not that none exists. Putnam County’s page lists the county offices to call.
Off-grid gear
Going off-grid in Town of Philipstown means bringing your own water and power. The kit we’d start with:
These are affiliate links — we may earn a commission, at no cost to you. As an Amazon Associate, Bolthole Index earns from qualifying purchases.