Greene County, New York
Village of Tannersville is a village in Greene County, New York. Village of Tannersville adopts its own zoning, so inside its limits Village of Tannersville’s rules apply, not the county’s. 12 rules below are quoted from official sources and independently re-checked, most recently on November 12, 2026. Rules for unincorporated land are on the Greene County page.
Construction in Tannersville village
“the work covered by this application may not be commenced before the issuance of a zoning and building permit.”
Construction inside Tannersville village; village building department administers the NYS Uniform Code
“for the issuance of a zoning and building permit pursuant to the nys uniform fire prevention and building code for the construction of buildings, additions or alterations”
Permitted construction in Tannersville village
“note: inspections by village of tannersville inspector are required at the following schedule: (you must call for inspections with 48 hours prior notice).”
Buildings in Tannersville village
“6. no building shall be occupied or used in whole or in part for any purpose whatsoever until a certificate of occupancy shall have been granted.”
Land inside Tannersville village, Greene County
“this action of the village of tannersville, new york in the adoption of this zoning code is authorized under the new york state home rule law, article 2.”
Tannersville village
“article 2: establishment of zoning districts 13 articles: r l - residential single family: low density district 15 article 4: r2 - residential single family: medium density district”
RL (Residential Single Family: Low Density) district, inside Tannersville village
minimum building size: >= 1200 square feet
“one dwelling unit per acre 75 linear feet 50 feet 25 feet none 1200 square feet”
RL district, inside Tannersville village; expressed as maximum density, minimum frontage
maximum density: one dwelling unit per acre · minimum frontage: >= 75 linear feet
“one dwelling unit per acre 75 linear feet 50 feet 25 feet none 1200 square feet”
RL district, inside Tannersville village
front yard setback: >= 50 feet · side and rear yard setbacks: >= 25 feet
“one dwelling unit per acre 75 linear feet 50 feet 25 feet none 1200 square feet”
BL (General Business) district, inside Tannersville village
maximum building height: <= 40 feet (3 stories)
“maximum building height 3 stories (40 feet) minimum building size 1,000 square feet”
Short-term rentals (under 30 consecutive nights) in all zones inside Tannersville village
rental period defining STR: < 30 consecutive nights
“a. owners shall not use their property as a short-term rental without obtaining a revocable short-term rental permit from the village of tannersville chief enforcement officer.”
Building/zoning permits in Tannersville village
“permits for minor construction may be granted the same day:. permits for major construction may take ten days for review before a permit is granted.”
We looked and could not find an official answer yet. Silence is not permission; ask Village of Tannersville or Greene County directly.
Each answer was extracted from an official source and independently re-checked against that source by a second reviewer. That is an evidence check, not legal advice. Rules change; confirm with the authority before you buy or build.
Unanswered questions are usually a sign that Village of Tannersville publishes no rule on the point, not that none exists. Greene County’s page lists the county offices to call.
Off-grid gear
Going off-grid in Village of Tannersville means bringing your own water and power. The kit we’d start with:
These are affiliate links — we may earn a commission, at no cost to you. As an Amazon Associate, Bolthole Index earns from qualifying purchases.